Electrolux EKG 600102 Instruction Booklet page 31

Replacement of gas oven
burner nozzle
To replace the gas oven nozzle, follow
this procedure:
1. Remove the bottom plate of the oven
cavity ("A");
2. Undo the two fixing screws ("C")
which keep the oven gas burner in
place
3. Gently slide the oven gas burner off
the injector support ("D") and slowly
move it to the left hand side, taking
care not to cause stress to the spark
plug connection wire ("E") and the
thermocouple ("F") conductor;
4. With a socket spanner 7 unscrew and
remove the gas burner injector ("D"),
and replace it with the required one
(see table "Burner characteristics");
5. Reassemble the burner following the
same procedure in reverse.
6. Replace the gas type sticker (it is
located near the gas connection
ramp) with the one relevant to the new
gas type which is supplied with the
injector kit.
Minimum level adjustment of
gas oven burner
After setting the oven on maximum
temperature with door closed for about
10 minutes, turn the knob to minimum.
To reach the thermostat by-pass screw
("G") and adjust the minimum level, act as
follows:
1. take out the gas oven and electric
grill control knob.
2. With a thin screwdriver, adjust the
by-pass screw positioned in the
centre of the gas tap control shaft
(see picture). If changing from natu-
ral gas 20 mbar to liquid gas,
electrolux 31