Electrolux EKG501102 User Manual page 8

electrolux
8
Oven light
The oven is equipped with a lamp.
To switch on the light in the oven press the
switch on the control panel.
Mechanical timer
Turn the regulation knob clockwise to
maximum position and than turn it back to
the position corresponding to the period of
time necessary for the cooking.
At the end of the time selected an acoustic
signal intervenes which stops automatically.
The timer does not interrupt the operation of
the oven upon action of the acoustic signal.
The Hob Burners
Each burner has a safety device. In case the
flame dies out the safety device stops the
gas supply.
Off
Maximum position
Minimum position
Use the maximum level for boiling and the
minimum for simmering.
Always choose positions between the
minimum and maximum, never between
maximum and off.
Warning: do not use cooking vessels
bigger then the overlap its edges on
the hotplate.
Ignition of the burners
• Push the electronic ignition knob for
obtaining sparkles or during a power cut
hold a flame near the hob burner
• In the same time push and turn the hob
control knob to the big flame symbol and
keep the knob pressed for maximum 10
seconds until the gas ignites.
Upon ignition, adjust the flame as required.
If for any reason the flame should extinguish
turn the control knob to the " " position,
leave for at least 1 minute and then re-ignite.
If after a few attempts the burner does not
ignite, check that the burner ring and its cap
are correctly positioned.
The Ignition electrode
The electric ignition is obtained through a
ceramic electrode which contains a metal
electrode.
Keep the ignition electrod very clean, to
avoid difficult lighting, and check that the
burner crown holes are not obstructed.
Burner
cap
Burner
ring
IIgnition