Rear Wheel - Yamaha Drag Star XVS250 Owner's Manual

PERIODIC MAINTENANCE AND MINOR REPAIR
1. Speedometer gear unit retainer
3. Insert the wheel axle.
4. Lower the front wheel so that it is
on the ground.
5. Tighten the wheel axle and front
6
wheel axle pinch bolt to the speci-
fied torques, and then install the
rubber cap.
Tightening torques:
Wheel axle:
59 Nm (5.9 m·kgf, 43 ft·lbf)
Front wheel axle pinch bolt:
20 Nm (2.0 m·kgf, 14 ft·lbf)
6. While applying the front brake,
push down hard on the handlebars
several times to check if the front
fork compresses and rebounds
smoothly.
7. Connect the speedometer cable.
6-33

Rear wheel

To remove the rear wheel
WARNING
G It is advisable to have a Yamaha
dealer service the wheel.
G
Securely support the motor-
cycle so that there is no danger
of it falling over.
1. Loosen the axle nut and the brake
torque rod nut at the brake shoe
plate.
1. Axle nut
2. Brake torque rod
3. Brake torque rod nut and bolt
4. Brake rod
5. Brake pedal free play adjusting nut
EAU25080
EAU25430
EWA10820