Yamaha Midnight Star XVS950A Owner's Manual page 24

INSTRUMENT AND CONTROL FUNCTIONS
Right
3
5
1. Engine stop switch "
2. "SELECT" switch
3. "RESET" switch
4. Start switch " "
5. Hazard switch " "
Pass switch " "
Press this switch to flash the headlight.
Dimmer switch "
Set this switch to "
beam and to " " for the low beam.
Turn signal switch "
To signal a right-hand turn, push this
switch to " ". To signal a left-hand
turn, push this switch to "
leased, the switch returns to the center
position. To cancel the turn signal
lights, push the switch in after it has re-
turned to the center position.
1
Horn switch "
Press this switch to sound the horn.
2
3
Engine stop switch "
4
Set this switch to "
the engine. Set this switch to "
/ "
stop the engine in case of an emergen-
cy, such as when the vehicle overturns
or when the throttle cable is stuck.
Start switch "
EAU12350
Push this switch to crank the engine
with the starter. See page 5-1 for start-
ing instructions prior to starting the en-
EAU12400
gine.
/ "
" for the high
The engine trouble warning light will
come on when the key is turned to "ON"
EAU12460
and the start switch is pushed, but this
/ "
does not indicate a malfunction.
". When re-
Hazard switch "
With the key in the "ON" or "
tion, use this switch to turn on the haz-
ard lights (simultaneous flashing of all
EAU12500
" turn signal lights).
The hazard lights are used in case of
an emergency or to warn other drivers
EAU12660 when your vehicle is stopped where it
/ "
might be a traffic hazard.
" before starting
" to
NOTICE
Do not use the hazard lights for an
extended length of time with the en-
gine not running, otherwise the bat-
tery may discharge.
EAU12711
"
"SELECT" switch
This switch is used to perform selec-
tions in the odometer and tripmeters, to
set the clock and to set the brightness
control mode of the multi-function
EAU41700
meter unit.
See "Multi-function meter unit" on page
3-5 for detailed information.
3-9
EAU12733
"
" posi-
ECA10061
EAU44602