Yamaha YZF-R1 Owner's Manual page 34

INSTRUMENT AND CONTROL FUNCTIONS
Right
1
2
3
3
1. Engine stop switch "
2. Drive mode switch "MODE"
3. Start switch " "
Hazard switch
1. Hazard switch " "
Pass switch " "
Press this switch to flash the head-
lights.
Dimmer switch "
Set this switch to "
beam and to "
Turn signal switch "
To signal a right-hand turn, push this
switch to "
turn, push this switch to "
leased, the switch returns to the center
position. To cancel the turn signal
/ "
lights, push the switch in after it has re-
turned to the center position.
Horn switch "
1
Press this switch to sound the horn.
Traction control system switch
"TCS"
This switch is used to select the traction
control system modes.
See "Traction control system" on page
3-22 for detailed information.
EAU12380
EAU12400
/ "
" for the high
" for the low beam.
EAU12460
/ "
". To signal a left-hand
". When re-
EAU12500
"
EAU51841
3-19
Engine stop switch " /
Set this switch to " " before starting
the engine. Set this switch to "
stop the engine in case of an emergen-
cy, such as when the vehicle overturns
or when the throttle cable is stuck.
Start switch " "
Push this switch to crank the engine
with the starter. See page 5-1 for start-
ing instructions prior to starting the en-
gine.
The engine trouble warning light will
come on when the key is turned to "ON"
and the start switch is pushed, but this
does not indicate a malfunction.
Hazard switch " "
With the key in the "ON" or "
tion, use this switch to turn on the haz-
ard lights (simultaneous flashing of all
turn signal lights).
The hazard lights are used in case of
an emergency or to warn other drivers
when your vehicle is stopped where it
might be a traffic hazard.
EAU12660
"
" to
EAU12711
EAU41700
EAU12733
" posi-