Table of Contents
Advertisement
Setting electronically:
1. Press the ON/OFF button.
If the only LED indicator illuminated is one that belongs to a programme button,
this means that this dishwashing cycle has been activated. The dishwashing cy
cle must be deselected:
Press function buttons 2 and 3 simultaneously for approx. 2 seconds.
The LED indicators of all the programme buttons that can be selected light up.
2. Press function buttons 2 and 3 simultaneously and keep them pressed.
The LED indicators for function buttons 1 to 3 will flash.
3. Press function button 1.
The LED indicator for function button 1 will flash.
The LED indicator for the end of the dishwashing cycle will flash simultaneously:
– The number of times that the LED indicator for the end of the dishwashing cy
cle flashes corresponds to the hardness setting.
– This sequence of flashes is repeated several times, with a 3 second pause in
between.
4. Pressing function button 1 increases the hardness setting by 1 degree.
(Exception: hardness setting 1 follows hardness setting 10).
5. When the hardness setting is correct, press the ON/OFF button.
The hardness setting is now saved.
If the water softener is set electronically to "1", this switches off the control in
dicator for special salt.
Water hardness
1)
in °d
in mmol/l
51 70
43 50
37 42
29 36
23 28
19 22
15 18
11 14
4 10
below 4
1) (°d) German degree, measure of the hardness of water
2) [mmol/l] millimol per litre, international unit for water hardness
3) On this setting the length of the dishwashing cycle may be slightly longer.
*) factory setting
2)
Range
9,0 12,5
7,6 8,9
6,5 7,5
IV
5,1 6,4
4,0 5,0
3,3 3,9
III
2,6 3,2
1,9 2,5
II
0,7 1,8
I/II
below 0.7
I
Prior to using for the first time
Adjusting the hardness setting
Manual
Electronic
2*
1
no salt
necessary
Number of
flashes
3)
10
10
9
9
8
8
7
7
6
6
5*
5
4
4
3
3
2
2
1
1
9
Hide quick links:
Advertisement
Table of Contents
