Setting Manually; Setting Electronically - Electrolux FAVORIT 88020I User Manual

8
Set the water softener
°dH
4 - 10
< 4

Setting manually

The dishwasher is factory set at position 2.
1. Open the dishwasher door.
2. Remove the lower basket from the dish-
washer.
3. Turn the water hardness dial to position 1
or 2 (see table).
4. Replace the lower basket.

Setting electronically

The dishwasher is factory set at level 5.
1. Press the On/Off button. The dishwasher must be in setting mode.
2. Press simultaneously and keep pressed buttons B and C, until the lights of buttons A,
B and C start flashing.
3. Press button A, the lights of buttons B and C turn off while the light of button A goes
on flashing. In the digital display is visible the current level.
Examples:
displayed = level 5
displayed = level 10
4. To change the level, press button A. Each time the button is pressed the level changes
(for the selection of the new level see the chart).
Examples: if the current level is 5, by pressing button A once, level 6 is selected. if the
current level is 10, by pressing button A once, level 1 is selected.
5. To memorise the operation, switch off the dishwasher by pressing the On/Off button.
Water hardness
°TH mmol/l
7 - 18 0,7 - 1,8
< 7
Adjusting the water hardness
manually
1
< 0,7 1
setting
electronically
level 2
level 1
Use of salt
yes
no