Table of Contents
Advertisement
What to do if ...
Problem
The oven does not heat
up
The oven lighting is not
operating
F11 appears in the clock
display
F2 appears in the clock
display
An error code not listed
above appears in the time
display
If you are unable to remedy the problem by following the above sugges-
tions, please contact your dealer or the Customer Care Department.
1
Warning! Repairs to the appliance are only to be carried out by qualified service
engineers. Considerable danger to the user may result from improper repairs.
Possible cause
The oven is not switched on
The clock is not set
The required settings have not
been set
The oven's automatic cut-out
has been triggered.
The fuse in the house's electri-
cal wiring (fuse box) has been
tripped
The oven bulb is faulty
The meat probe has short
circuited or the plug of the
meat probe is not firmly in po-
sition in the socket
Door not properly closed or
door lock defective
Fault in the electronics
What to do if ...
Remedy
Switch the oven on
Set the current time on the
clock
Check the settings
See Automatic cut-out
Check fuse. If the fuses trip re-
peatedly, please call an au-
thorised electrician
Change the oven bulb
Insert the plug of the meat
probe as far as it will go into
the socket on the side wall of
the oven
Close door properly;
Turn the appliance off and on
again via the house fuse or
the safety switch in the fuse
box;
If displayed again, please con-
tact the Customer Care De-
partment
Switch off the appliance via
the house fuse or the safety
switch in the fuse box and
switch it on again
If displayed again, please con-
tact your local Service Force
Centre
59
Advertisement
Table of Contents
