On The Windscreen; Adjusting The Unit Bracket; Adding The Traffic Assist; Removing The Traffic Assist - Becker TRAFFIC ASSIST Z101 Operating Instructions Manual

Table of Contents

Advertisement

>>>
GERNARAL OPERATION

On the windscreen

The unit holder can be attached directly
> D
to the windscreen via the suction mecha-
> GB
nism.
> Find a suitable position.
> F
> Press the base
face
against the windshield.
1
> I
> Rotate the unit bracket so that the sup-
> E
port plate is roughly in the direction of
viewing required.
> NL
> Press the lever
The bracket will have stuck firmly to the
windscreen. It can now be set precisely.
To remove, actuate the lever
20

Adjusting the unit bracket

> Unscrew the fastening screw
> Move the carrier plate
with its suction sur-
3
> Tighten the fastening screw
downwards.
2

Adding the Traffic Assist

again.
2
> Position the Traffic Assist with the at-
> Press the Traffic Assist onto the carrier

Removing the Traffic Assist

Press the clip
one finger and remove the unit from the
unit holder using your free hand.
the carrier plate
can be moved with-
5
out excessive force.
to the re-
5
quired position and hold it in this posi-
tion.
ciently so that the Traffic Assist is held
securely in place when the vehicle is in
motion.
tachment points on the bottom of the
housing on the carrier plate
5
plate
without using excessive force
5
until the clip
engages in the attach-
6
ment point.
on the unit holder with
6
Switching the Traffic Assist
until
4
on/off
The unit is switched on and off using the
key
.
suffi-
4
.

Switching on

> Press the key
The unit is switched on. The manufactur-
er's logo appears on the touch screen.
for a few seconds.

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the TRAFFIC ASSIST Z101 and is the answer not in the manual?

Table of Contents