Using The Map Display; Applies Only To The Bluetooth®-Enabled Traffic Assist; Repeat The Last Voice Prompt; Changing The Announcement Volume - Becker TRAFFIC ASSIST 7977 Instructions For Use Manual

>>> NAVIGATIONAL MODE
The following function keys appear in the
toolbar:
> EN
Icon Meaning
See "Display route (toolbar)"
on page 69.
Readout TMC messages.
The TMC-function is not
available for Australia.
See "Daytime - Night-time
design (toolbar)" on page 70.
See "Change display (tool-
bar)" on page 70.
See "Point northwards (tool-
bar)" on page 70.
See "Available POIs along the
route (toolbar)" on page 70.
See "Play" on page 86.
Call up the telephone func-
tion*. See "Calling up tele-
phone mode" on page 74.
68

Using the map display

Repeat the last voice prompt

During route guidance, the system an-
nounces important information, e.g. the
next driving manoeuvre. The last an-
nouncement can be repeated with updat-
ed information.
> Press the preview area while route guid-
ance is active and the toolbar deactivat-
ed.
The last announcement is repeated with
updated information. The volume is also
displayed.

Changing the announcement volume

The volume of announcements can be
adjusted.
*Applies only to the Bluetooth®-enabled Traffic Assist 7977
> Press the preview area while route
guidance is active and the toolbar
deactivated.
The bar display indicates the volume.
> Press
or to increase or
decrease the volume.
> Press in order to mute the
announcements.
> Press
again in order to cancel the
mute function.
WARNING
The volume of the navigation unit
should be set so that noises outside the
vehicle can be heard.
The bar display disappears again automat-
ically after three seconds if no button is
pressed.