Ending The Data Connection; Manual Network Selection - Honeywell Dolphin 6000 User Manual

9. Select Connect on the pop-up menu.
10. The network icon in the navigation bar shows GSM radio is attempting to connect.
Note: Data connection failure occurs if terminal is in use for a voice call while attempting a data connection. Voice and data
cannot be used at the same time. A voice call has priority over a data connection. Active data connection is automatically
set in "park" mode and data is "retrieved" when the voice call ends.
11. When the connection is complete, the network icon changes to a Signal Strength Icon. Data can now be sent over GSM.

Ending the Data Connection

The default setting makes the data connection disconnect after a specific amount of time passes without use. This amount of
time is determined by the ISP.
To end data connection manually, tap the network icon in navigation bar and tap Disconnect on the pop-up menu.

Manual Network Selection

Select either the Automatic or Manual network selection in the Network tab. The terminal defaults to Automatic network selec-
tion.
9 - 10