Safety Harness; Hand Brake - Baby Jogger F.I.T Assembly Instructions Manual

Safety Harness

1
Unclip top of shoulder strap from the seat and
re-clip on the pair of seat loops closest to your
child's shoulder height.
Warning: The shoulder straps must be over the child's shoulders
and the lap belt section must be over the child's lap. The harness
must be tightened so that the child is fully restrained yet
comfortable. as a guide, you should be leaving a gap of no more
than two finger widths between the harness and the child's body.
6
Warning: always
use the crotch strap
in combination with
the shoulder straps
and waist belt.
2
To adjust the shoulder and crotch strap length:
Remove the shoulder pads and slide the plastic
guide up or down to lengthen or shorten.
3
To buckle the harness: Simply push side buckle
into center buckle until it locks into place.
To unbuckle: Push one side of the center
button and pull the corresponding side buckle
away from the center buckle. Repeat to
unbuckle other side.
Brake

Hand Brake

B
A
C
• Your stroller is equipped with a hand brake
for your jogging convenience.
Adjusting the hand brake: If you do not have
good braking action, simply squeeze the brake
handle (A) five or six times. If the problem
persists, loosen the brake's cylinder ring (B) to
adjust the small ring (C) and then move the
small ring away from the handle to tighten the
cable. (Please do not over tighten!) To lock the
rings, tighten the cylinder ring (B) against the
handle while holding the small ring (C) in place.
Warning: Engage
parking device
before loading
and unloading
passenger.
• Simply push
brake pedal down
to engage rear
parking brake and
lift up to release.
1
To use the hand brake make sure brake pads
are properly installed (see page 3). Squeeze
the hand brake to give you better control over
your stroller while jogging or running.
2
To rotate the hand brake's position on the
handle bar, loosen the bolt using the supplied
Allen wrench. Rotate the hand brake assembly
on the handlebar until it is in a comfortable
position. Tighten the bolt to secure hand brake.
7