Replacing An Auxiliary Light Bulb; Supporting The Motorcycle - Yamaha MidnightStar XV1900A Owner's Manual

PERIODIC MAINTENANCE AND ADJUSTMENT
Replacing an auxiliary light
bulb
This model is equipped with two auxil-
iary lights. If an auxiliary light bulb burns
out, replace it as follows.
1. Remove the headlight unit. (See
page 6-26.)
2. Remove the auxiliary light bulb
socket (together with the coupler)
by turning the socket counterclock-
wise.
6
1. Auxiliary light bulb socket
3. Remove the burnt-out bulb by pull-
ing it out.
EAU40763
1. Auxiliary light bulb
4. Insert a new bulb into the socket.
5. Install the socket (together with the
coupler) by pushing it in and turn-
ing it clockwise.
6. Install the headlight unit.
6-30

Supporting the motorcycle

Since this model is not equipped with a
centerstand, follow these precautions
when removing the front and rear
wheel or performing other maintenance
requiring the motorcycle to stand up-
right. Check that the motorcycle is in a
stable and level position before starting
any maintenance. A strong wooden
box can be placed under the engine for
added stability.
To service the front wheel
1. Stabilize the rear of the motorcycle
by using a motorcycle stand or, if
an additional motorcycle stand is
not available, by placing a jack un-
der the frame in front of the rear
wheel.
2. Raise the front wheel off the
ground by using a motorcycle
stand.
To service the rear wheel
Raise the rear wheel off the ground by
using a motorcycle stand or, if a motor-
cycle stand is not available, by placing
EAU24350