Rear Wheel - Yamaha TW125 Owner's Manual

PERIODIC MAINTENANCE AND MINOR REPAIR
1
1. Retainer
2. Speedometer cable
NOTE:
Make sure that there is enough
space between the
6
before inserting the brake disc and
that the slot in the speedometer gear
unit fits over the retainer on the fork
leg.
3. Insert the wheel axle, and then
install the axle nut.
4. Lower the front wheel so that it is
on the ground.
5. Tighten the axle nut to the speci-
fied torque.
2
Tightening torque:
Axle nut:
90 Nm (9.0 m·kgf)
6. Place the rubber cover at the
bottom of the right-side fork leg
in the original position.
7. Install the rubber cover at the
bottom of the left-side fork leg.
8. Connect the speedometer cable.
brake pads
1. Axle nut
2. Brake pedal free play adjusting nut
3. Brake rod
4. Brake camshaft lever
5. Drive chain adjusting plate

Rear wheel

To remove the rear wheel
w
6-40
2
3
5
a
1
8 It is advisable to have a
Yamaha dealer service the
wheel.
8 Securely support the motorcy-
cle so that there is no danger
of it falling over.
1. Loosen the axle nut.
4
EAU03519
EW000122