Yamaha Sniper T135 SE Owner's Manual page 67

3. Loosen the brake torque rod nut at
the brake shoe plate.
4. Disconnect the brake torque rod
from the brake shoe plate by re-
moving the cotter pin, the nut, the
washer and the bolt.
1. Brake torque rod
2. Brake torque rod cotter pin
3. Brake torque rod nut and bolt
5. Place the motorcycle on the cen-
terstand.
6. Remove the brake pedal free play
adjusting nut, and then disconnect
the brake rod from the brake cam-
shaft lever.
PERIODIC MAINTENANCE AND MINOR REPAIR
1. Wheel axle
2. Washer
3. Brake rod
4. Brake pedal free play adjusting nut
5. Brake camshaft lever
7. Remove the axle nut and the
washer, and then pull the wheel
axle out.
NOTE:
Do not remove the washer on the right
side of the wheel axle so as to not lose
it.
8. Push the wheel forward, and then
remove the drive chain from the
rear sprocket.
6-34
NOTE:
The drive chain does not need to be
disassembled in order to remove and
install the wheel.
9. Remove the wheel.
To install the rear wheel
1. Install the drive chain onto the rear
sprocket.
2. Install the wheel by inserting the
wheel axle from the right-hand
side.
NOTE:
Make sure the washer is installed onto
the wheel axle before installing the
wheel axle.
3. Install the washer and the axle nut.
4. Install the brake rod onto the brake
camshaft lever, and then install the
brake pedal free play adjusting nut
onto the brake rod.
5. Connect the brake torque rod to
the brake shoe plate by installing
the bolt, the washer and the nut.
6. Adjust the drive chain slack. (See
page 6-22.)
EAU37751
6