Operation And Important Riding Points; Starting And Warming Up A Cold Engine - Yamaha Sniper T135 SE Owner's Manual

Sniper 2005
Table of Contents

Advertisement

WARNING
G
Become
thoroughly
with all operating controls and
their functions before riding.
Consult a Yamaha dealer re-
garding any control or function
that you do not thoroughly un-
derstand.
G
Never start the engine or oper-
ate it in a closed area for any
length of time. Exhaust fumes
are poisonous, and inhaling
them can cause loss of con-
sciousness and death within a
short time. Always make sure
that there is adequate ventila-
tion.
G
Before starting out, make sure
that the sidestand is up. If the
sidestand is not raised com-
pletely, it could contact the
ground and distract the opera-
tor, resulting in a possible loss
of control.

OPERATION AND IMPORTANT RIDING POINTS

EAU15950
Starting and warming up a
EWA10270
cold engine
1. Turn the key to "ON".
familiar
2. Shift the transmission into the neu-
tral position.
NOTE:
When the transmission is in the neutral
position, the neutral indicator light
should be on, otherwise have a
Yamaha dealer check the electrical cir-
cuit.
3. Place the vehicle on the center-
stand.
WARNING
Before starting the engine, make
sure the transmission is in neutral
and that the vehicle is placed on the
centerstand.
4. Turn the starter (choke) on and
completely close the throttle. (See
page 3-7.)
5. Start the engine by pushing the
start switch or by pushing the kick-
starter lever down.
EAU37640
NOTE:
If the engine fails to start by pushing the
start switch, release the switch, wait a
few seconds, and then try again. Each
starting attempt should be as short as
possible to preserve the battery. Do not
crank the engine more than 10 seconds
on any one attempt. If the engine does
not start with the starter motor, try using
the kickstarter.
CAUTION:
The coolant temperature warning
light should come on when the key
EWA14200
is turned to "ON", and then go off af-
ter a few seconds. If the coolant tem-
perature warning light comes on
after starting, immediately stop the
engine, and have a Yamaha dealer
check the electrical circuit.
6. After starting the engine, move the
5-1
starter (choke) back halfway.
ECA15170
5

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents