Yamaha Sniper T135 SE Owner's Manual page 43

1. Engine oil drain bolt
2. O-ring
3. Compression spring
4. Strainer
5. Oil pan
CAUTION:
When removing the engine oil drain
bolt, the O-ring, compression
spring, and oil strainer will fall out.
Take care not to lose these parts.
NOTE:
Check the O-ring for damage and re-
place it if necessary.
4. Clean the engine oil strainer with
solvent.
PERIODIC MAINTENANCE AND MINOR REPAIR
NOTE:
Skip steps 5–7 if the oil filter element is
not being replaced.
5. Remove the oil filter element cover
by removing the bolts.
ECA11000
1. Bolt
2. Oil filter element cover
6. Remove and replace the oil filter
element and O-ring.
1. Oil filter element
2. O-ring
7. Install the oil filter element cover by
NOTE:
Make sure that the O-ring is properly
seated.
8. Install the engine oil strainer, com-
6-10
installing the bolts, then tightening
them to the specified torque.
Tightening torque:
Oil filter element cover bolt:
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
pression spring, O-ring and engine
oil drain bolt, and then tighten the
drain bolt to the specified torque.
6