Yamaha Sniper T135 SE Owner's Manual page 45

NOTE:
The coolant should be between the
minimum and maximum level marks.
1. Maximum level mark
2. Minimum level mark
3. If the coolant is at or below the
minimum level mark, remove cowl-
ing A. (See page 6-5.)
4. Loosen the coolant reservoir cap
retainer bolt, and then lift the re-
tainer upward.
5. Remove the coolant reservoir cap,
and then add coolant to the maxi-
mum level mark.
PERIODIC MAINTENANCE AND MINOR REPAIR
1. Coolant reservoir cap retainer bolt
2. Coolant reservoir cap retainer
3. Coolant reservoir cap
Coolant reservoir capacity (maximum
level): YAMAHA GENUINE COOLANT
0.28 L (0.30 US qt) (0.25 Imp.qt)
CAUTION:
use only YAMAHA GENUINE
G
COLANT. Using coolan other than
recommended, could cause damage
to oil seal and o-rings, as whell
as to the cooling system.
G
If water has been used instead
of coolant, replace it with cool-
ant as soon as possible, other-
wise the engine may not be
6-12
sufficiently cooled and the cool-
ing system will not be protected
against frost and corrosion.
G If water has been added to the
coolant, have a Yamaha dealer
check the antifreeze content of
the coolant as soon as possible,
otherwise the effectiveness of
the coolant will be reduced.
WARNING
Never attempt to remove the radiator
cap when the engine is hot.
6. Install the coolant reservoir cap.
7. Place the coolant reservoir cap re-
tainer in the original position, and
ECA10470
then tighten the bolt to the speci-
fied torque.
Tightening torque:
Coolant reservoir cap retainer bolt:
7.0 Nm (0.7 m·kgf, 5.1 ft·lbf)
8. Install the cowling.
EWA10380
6