Sidestand - Yamaha DT125R Owner's Manual

cC
The YPVS has been set and exten-
sively tested at the Yamaha facto-
ry. Changing these settings with-
out sufficient technical knowledge
may result in poor performance of
or damage to the engine.
YPVS operation noises can be heard
in the following instances:
8 When the key is turned to "ON"
and the engine is started.
8 When the engine stalls with the
key in the "ON" position.
cC
If the YPVS does not operate, have
a Yamaha dealer check it.
INSTRUMENT AND CONTROL FUNCTIONS
EC000023

Sidestand

The sidestand is located on the left
side of the frame. Raise the side-
stand or lower it with your foot while
holding the motorcycle upright.
NOTE:
The built-in sidestand switch is part of
the ignition circuit cut-off system,
which cuts the ignition in certain situ-
ations. (See further down for an
explanation of the ignition circuit cut-
off system.)
EC000024
EAU00330
w
The motorcycle must not be ridden
with the sidestand down, or if the
sidestand
moved up (or does not stay up),
otherwise the sidestand could con-
tact the ground and distract the
operator, resulting in a possible
loss of control. Yamaha's ignition
circuit cut-off system has been
designed to assist the operator in
fulfilling the responsibility of rais-
ing the sidestand before starting
off. Therefore, check this system
regularly as described below and
have a Yamaha dealer repair it if it
does not function properly.
3-15
EW000044
cannot be properly
3