Rear Wheel - Yamaha DT125R Owner's Manual

2
2
1. Axle nut
2. Swingarm end bolt (×2)

Rear wheel

Wheel ( r e ar )
w
8 It is advisable to have a
Yamaha dealer service the
wheel.
8 Securely support the motorcy-
cle so that there is no danger
of it falling over.
1. Loosen the axle nut.
2. Lift the rear wheel off the ground
according to the procedure on
page 6-39.
3. Remove the swingarm end bolts.
PERIODIC MAINTENANCE AND MINOR REPAIR
1
1. Chain adjusting plate
4. Turn the drive chain adjusting
EAU04237
plate on each side of the
swingarm fully in direction a.
EW000122
5. Push the wheel forward, and
then remove the drive chain from
the rear sprocket.
NOTE:
The drive chain does not need to be
disassembled in order to remove and
install the rear wheel.
6. Pull the wheel axle out from the
left-hand side, and then remove
the wheel by pulling it back.
cC
1
Do not apply the brake after the
a
wheel has been removed together
with the brake disc, otherwise the
brake pads will be forced shut.
6-42
ECA00048
6