Replacing An Auxiliary Light Bulb; Front Wheel (Fz1-S) - Yamaha Fazer FZ1-S Owner's Manual

Replacing an auxiliary light
bulb
This model is equipped with two auxil-
iary lights. If an auxiliary light bulb burns
out, replace it as follows.
1. Remove panel B (if replacing the
left auxiliary light bulb) or panel A
(if replacing the right auxiliary light
bulb). (See page 6-7.)
2. Remove the auxiliary light socket
(together with the bulb) by turning
the socket counterclockwise.
1. Auxiliary light bulb
2. Auxiliary light bulb socket
3. Remove the defective bulb by pull-
ing it out.
4. Insert a new bulb into the socket.
PERIODIC MAINTENANCE AND MINOR REPAIR
EAU27011 5. Install the auxiliary light socket (to-
gether with the bulb) by pushing it
in and turning it clockwise.
6. Install the panel.

Front wheel (FZ1-S)

For the ABS model, have a Yamaha
dealer remove and install the wheel.
To remove the front wheel
G
G
1. Place the vehicle on the center-
2. Loosen the front wheel axle pinch
6-36
WARNING
WARNING
It is advisable to have a Yamaha
dealer service the wheel.
Securely support the motor-
cycle so that there is no danger
of it falling over.
stand.
bolt, then the wheel axle and the
brake caliper bolts.
EAU44790
EWA14840
EAU40060
EWA10820
6