Table of Contents
Advertisement
20 electrolux
2. Remove the little plastic cover from the
door plastic trim and refit on the opposite
side (t3).
3. Remove the panel (t4). If it is necessary
use a screwdriver very carefully. Un-
screw the screw on the other side. Re-
move the upper door mount (t5). Place
them in an empty plastic bag.
t4
4. Remove the upper door.
5. Unscrew the screw and remove the door
stopper (d1). Attach it reversed on the
other side.
d1
6. Unscrew the middle hinge (m2). Remove
the plastic spacer (m1).
7. Remove the lower door.
t5
8. Remove using a tool the cover (b1). Un-
9. Re-insert the cover (b1) on the opposite
10. Remove the stoppers (d1) and move to
11. Remove the left-hand cover pin of the
12. Fit the pin of the middle hinge (m5) into
13. Re-insert the lower door on the pivot pin
14. Re-screw the middle hinge (m1) on the
m1 m2
m5
m3
m4
screw the lower hinge pivot (b2) and the
spacer (b3) and place them on the op-
posite side.
side.
b3
the other side of the doors.
middle hinge (m3,m4) and move to the
other side.
the left-hand hole of the lower door.
(b2).
opposite side . Do not forget the plastic
spacer (m2) inserted under the middle
hinge.
b1
b2
Advertisement
Table of Contents
