Table of Contents
Advertisement
18 electrolux
A
Electrical Connection
Caution! Any electrical work required to
install this appliance should be carried
out by a qualified electrician or
competent person.
Warning! This appliance must be
earthed.
The manufacturer declines any liability
should these safety measures not be
observed.
1
5
Important! The wires in the mains lead are
coloured in accordance with the following
code:
B
2
3
4
1
Green and Yellow:
3
Brown:
5
Blue:
As the colours of the wires in the mains lead
of this appliance may not correspond with
the coloured markings identifying the termi-
nals in your plug, proceed as follows:
1. Connect the wire coloured green and yel-
low to the terminal marked either with the
letter "E" or by the earth symbol
coloured green and yellow.
2. Connect the wire coloured blue to the
terminal either marked with the letter
"N" or coloured black.
3. Connect the wire coloured brown to the
terminal either marked with the "L" or col-
oured red.
4. Check that no cut, or stray strands of wire
is present and the cord clamp
cure over the outer sheath.
5. Make sure the electricity supply voltage is
the same as that indicated on the appli-
ance rating plate.
6. Switch on the appliance.
The appliance is supplied with a 13 amp plug
2
fitted
. In the event of having to change
the fuse in the plug supplied, a 13 amp ASTA
approved (BS 1362) fuse must be used.
Warning! A cut off plug inserted into a
13 amp socket is a serious safety
(shock) hazard. Ensure that it is
disposed of safely.
Rear spacers
In the bag with the documentation, there
are two spacers which must be fitted as
shown in the figure.
Slacken the screws and insert the spacer
under the screw head, then tighten again the
screws.
Earth
Live
Neutral
or
4
is se-
Advertisement
Table of Contents
