Replacing The Lamp - Electrolux ENA34305W User Manual

16 electrolux
Problem
Water flows into the re-
frigerator.
Water flows on the
ground.
There is too much frost
and ice.
The temperature in the
appliance is too low.
The temperature in the
appliance is too high.
The temperature in the re-
frigeration is too high.
The temperature in the
freezer is too high.
The appliance does not
operate.
The lamp does not work.
If your appliance is still not working properly
after making the above checks, contact the
After Sales Centre.

Replacing the lamp

If you want to replace the bulb, do these
steps:
1. Break the circuit of the appliance.
2. Unscrew the lamp cover securing screw.
3. Unhook the moving part by pressing it as
shown in the figure.
4. Replace the bulb with one of the same
power (the maximum power is shown on
the light bulb cover)
5. Fix the lamp cover in place.
Possible cause
The water outlet is clogged.
Products prevent that water flows
into the water collector.
The melting water outlet does not
flow in the evaporative tray above
the compressor.
Products are not wrapped prop-
erly.
The door is not closed correctly.
The Temperature regulator may
be set incorrectly.
The Temperature regulator may
be set incorrectly.
The Temperature regulator may
be set incorrectly.
The door is not closed correctly.
The product temperature is too
high.
Many products are stored at the
same time.
There is no cold air circulation in
the appliance.
Products are too near to each
other.
The appliance is switched off.
The mains plug is not connected
to the mains socket correctly.
The appliance has no power.
There is no voltage in the mains
socket.
The lamp is defective.
Clean the water outlet.
Make sure that products do not
touch the rear plate.
Attach the melting water outlet to
the evaporative tray.
Wrap the products better.
Refer to "Closing the door".
Set a higher temperature.
Set a higher temperature.
Set a lower temperature.
Refer to "Closing the door".
Let the product temperature de-
crease to room temperature before
storage.
Store less products at the same
time.
Make sure that there is cold air cir-
culation in the appliance.
Store products so that there is cold
air circulation.
Switch on the appliance.
Connect the mains plug to the
mains socket correctly.
Connect a different electrical appli-
ance to the mains socket. Contact
a qualified electrician.
Refer to "Replacing the lamp".
6. Screw the lamp cover securing screw.
7. Reconnect the appliance.
8. Open the door and check if the light
comes on.
Solution