Tools Required - Poulan Pro PP5000P Instruction Manual

WARNING:
If received assembled,
repeat all steps to ensure your unit is properly
assembled and all fasteners are secure.
Examine parts for damage. Do not use dam-
aged parts.
NOTE:
If you need assistance or find parts
missing or damaged, call 1-800-554-6723.

TOOLS REQUIRED

S Hex wrench (provided)
INSTALLING PRUNER ATTACH-
MENT
CAUTION:
When removing or installing at-
tachments, place the unit on a flat surface for
stability.
1. Loosen the coupler by turning the knob
counterclockwise.
Coupler
LOOSEN
TIGHTEN Knob
2. Remove the tube cap from the pruner at-
tachment (if present).
3. Position locking/release button of attach-
ment into guide recess of coupler.
4. Push the attachment into the coupler until
the locking/release button snaps into the
primary hole.
5. Before using the unit, tighten the knob se-
curely by turning clockwise.
Coupler Primary Hole
Guide Recess
Locking/
Upper
Release
Tube Attachment
Button
WARNING:
Make sure the locking/
release button is locked in the primary hole
and the knob is securely tightened before op-
erating the unit.
SHOULDER STRAP ASSEMBLY
WARNING:
Proper shoulder strap and
handle adjustments are required before use.
The shoulder strap clamp must be installed as
shown above the assist handle on the upper
tube (powerhead end of unit).
ASSEMBLY
NOTE:
The lower shoulder strap clamp has
two spacer tabs attached. These tabs are
provided to adapt this attachment for use with
powerheads that have a 1" diameter upper
tube (the shoulder strap clamp will not tighten
down securely on the 1" diameter upper tube
without using these spacer tabs). The tabs
must be broken off completely before use and
placed over the screw holes on the lower
shoulder strap clamp. These tabs are not
needed for powerheads with a 7/8" upper
tube.
LOWER SHOULDER STRAP
CLAMP
Spacer Tabs
1. Place the upper shoulder strap clamp
over the upper tube above the handlebar.
2. Position the lower shoulder strap clamp
under the upper tube and align the upper
and lower clamp screw holes (use spacer
tabs between upper and lower clamps if
necessary to secure clamp, i.e. for 1" di-
ameter upper tube).
POWERHEAD
END
Lower Shoulder
Lower
Strap Clamp
3. Insert two screws into the screw holes.
4. Secure shoulder strap clamp by tighten-
ing screws with the hex wrench.
5. Try on shoulder strap and adjust for fit and
balance before starting the engine or begin-
ning a cutting operation.
6. Insert your right arm and head through the
shoulder strap and allow it to rest on your
left shoulder. Make sure the danger sign
is on your back and the hook is to the right
side of your waist.
NOTE:
A one-half twist is built in the shoul-
der strap to allow the strap to rest flat on the
shoulder.
6
Spacer Tabs
positioned for use
on 1" diameter
upper tube
Upper Shoulder
Strap Clamp
ATTACHMENT
END
Screws