Hardware Maintenance; Installing Memory Cards - Honeywell Dolphin 6110 User Manual

• Improper battery use may result in a fire, explosion or other hazard.
• We recommend use of Honeywell Li-Ion battery packs. Use of any non-Honeywell battery may pose a
personal hazard to the user.
• Only use the battery for the system for which it is specified. Do not use a battery in any other manner
outside its intended use in Dolphin terminals and peripherals.
• Ensure all components are dry prior to mating batteries with peripheral devices. Mating wet
components may cause damage not covered by the warranty.
• Replace defective batteries immediately; using a defective battery could damage the Dolphin terminal.
• Never throw a used battery in the trash. Promptly dispose of used batteries in accordance with local
regulations.
• Do not short-circuit a battery or throw it into a fire; it can explode and cause severe personal injury. Do
not allow metallic conductive objects to contact battery terminals.
• Don't use a battery in any other manner outside its intended use in Dolphin terminals and peripherals.
• Don't short-circuit a battery or throw it into a fire; it can explode and cause severe personal injury.
• Excessive discharge damages a battery. Recharge the battery when your terminal indicates low battery
power.
• If you observe that the Honeywell battery supplied is physically damaged in some way, send it to
Honeywell International Inc. or an authorized service center for inspection,
Repair on page 13-1
• Avoid dropping the terminal or battery. If the terminal or battery is dropped, especially on a hard
surface, and the user suspects damage, send it to a Honeywell International Inc. or an authorized
service center for inspection,
• Although your battery can be recharged many times, it will eventually be depleted. Replace it after the
battery is unable to hold an adequate charge.
• If you are not sure the battery or charger is working properly, send it to Honeywell International or an
authorized service center for inspection.
Charging
You can begin using the Dolphin terminal after charging the battery for an average of 7 1/2 hours for a
fully depleted battery. It takes less time to charge the battery if the battery has some charge.

Hardware Maintenance

When needed, clean the image/laser aperture window and the LCD display with a clean, non-abrasive,
lint-free cloth. The terminal can be cleaned with a damp cloth.

Installing Memory Cards

Note: Honeywell recommends the use of Single Level Cell (SLC) industrial grade microSD or microSDHC memory
cards with Dolphin terminals for maximum performance and durability. Only memory cards purchased directly
from Honeywell are supported. Contact a Honeywell sales representative for additional information on
qualified memory card options.
To install an SD card:
1. Open the access door on the left side.
2. Insert the SD card with the label facing upward.
Note: To remove an installed SD card while the access door is open, tap on the edge lightly to unlock the card; the
card pops out just enough for you to grab its edge and to pull it out.
3. Replace the access door.
3 - 10
see Product Service and Repair
see Product Service and
on page 13-1.