Back Panel - Honeywell Dolphin 6110 User Manual

Back Panel

HomeBase
Serial Port
USB Port
DC Power Jack
Connect the power cable to this power jack; see
page 10-4.
USB Port
The USB port is full-speed (v2.0). Using the USB cable, you can connect the base to a USB-
compliant device to facilitate USB communication to and from the terminal. USB
communication occurs through Microsoft ActiveSync (v.4.1 or higher). For more information
about ActiveSync setup, see
page 8-9.
Serial Port
The serial port supports serial communication between the terminal and another device. Note
that the connector is a DB9 Male connector, requiring a female connector on the serial cable.
The following four signals are supported:
• Transmitted Data
• Received Data
• Request to Send
• Clear to Send
Note: ActiveSync is not supported over the serial port.
Ethernet Port (eBase only)
Using an Ethernet cable, you can connect the eBase to an Ethernet-compliant device to facilitate Ethernet
communication to and from the terminal. This equipment is for indoor use only. The communication
wiring is limited to the inside of a building.
DC Power Jack DC Power Jack
Connecting and Synchronizing the Terminal and Workstation
Serial Port
USB Port
Ethernet Port
Powering the Dolphin HomeBase Device
eBase
DC Power Jack
on
on
10 - 3