Safety Instructions - Chauvet Stage Designer 50 User Manual

Safety Instructions

·
Please keep this User Manual for future consultation. If you sell the unit to another user, be sure that
they also receive this instruction booklet.
·
Always make sure that you are connecting to the proper voltage and that the line voltage you are
connecting to is not higher than that stated on decal or rear panel of the fixture.
·
This product is intended for indoor use only! To prevent risk of fire or shock, do not expose fixture to
rain or moisture.
·
Make sure there are no flammable materials close to the unit while operating.
·
In the event of serious operating problem, stop using the unit immediately. Never try to repair the unit
by yourself. Repairs carried out by unskilled people can lead to damage or malfunction. Please
contact the nearest authorized technical assistance center.
·
Don't connect the device to a dimmer pack.
·
Make sure power cord is never crimped or damaged.
·
Never disconnect power cord by pulling or tugging on the cord.
·
Do not operate this device in more than 104° F (40° C) ambient temperature conditions.
There are no user serviceable parts inside the unit. Do not open the housing or attempt any repairs
yourself.
In the unlikely event your unit may require service, please contact CHAUVET® at: 954-929-1115.2.
Introduction
Stage Designer 50
Please read these instructions carefully. It includes important information
about the installation, usage and maintenance of this product.
5 January 31, 2012