Playing A Scene With The Speed Slider; Playing A Scene With The Standard Beat; Change The Speed Mode Between; Auxiliary Controls - Chauvet Stage Designer 50 User Manual

Playing a Scene with the Speed Slider

Action ·
1.
2.
3.
4.

Playing a Scene with the Standard Beat

Action ·
1.
2.
3.
4.
5.
6.
Change the Speed Mode Between 5 & 10 Minutes
Action ·
1.
2.
3.

Auxiliary Controls

This is the process of assigning the Auxiliary controls. These will act as shortcuts and are most
commonly used for DMX strobe lights or DMX fog machines. However, they are not limited to these
functions, such as Pan/tilt control-very useful for remote followspot controls.
Stage Designer 50
Select your Scene as described in the
above sections.
Move the Speed slider to SHOW
MODE position (fully down).
Press and hold the Rec Speed button
& tap the corresponding Flash button
(13-24). The Scene tapped will no
longer run with the standard beat.
Now, you may move the Speed slider
to select your desired speed.
Tap the Mode select button to select
Chase◄►Scene mode.
Tap the Park button to select Mix
Chase mode. The LED lights,
indicating the selection.
Select your Scene as described in the
previous sections.
Move the Speed slider until the display
reads your desired value.
Press and hold Rec Speed button &
tap the Flash button (13-24) to store
the Scene. The Scene will now run
with the set time or beat when
engaged.
Repeat steps 4 & 5 to set a new beat
time.
Press and hold the Record button.
Tap the Flash button 5 or 10 three
times while holding down the Record
button.
The 5min or 10min LED should light,
indicating the Speed the slider is set to
run.
16
¥
Notes
Be sure AUDIO mode is disengaged.
Step #3 is not necessary if the selected Scene is
not recorded with the Standard beat.
¥
Notes
Be sure AUDIO mode is disengaged.
As an alternative to using the Speed slider to
input the speed, you may use the Tapsync
button (2) times to define your beat.
¥
Notes
January 31, 2012