Chauvet Stage Designer 50 User Manual page 16

Action ·
1. Press & hold RECORD & tap the Flash
button 7 or 8 (3) times. The display should
indicate activation of the mode.
2. There are 3 functions. FUNC 1 states that
the Auxiliary control is not assigned to any
channel. FUNC 2 refers o the auxiliary
controls working much like the channel
fader along with the flash buttons. FUNC 3
is somewhat different. The rotary knob acts
to set the total output of the flash button
below it.
3. While holding down the RECORD button,
select the function you wish for the auxiliary
control by pressing Flash button 1, 2, or 3.
Release the buttons.
4. To assign the auxiliary to a channel, press
the Flash button for the channel you wish to
assign the auxiliary control to. This sets the
channel assignment. The corresponding
Led above the channel will light, indicating
that the channel has ben assigned.
5. Record exit.
Stage Designer 50
¥
Notes
You may refer to the display for the functions
being edited.
Press 7 (3) times for AUX 1 patching, and 8 (3)
times for AUX 2 patching.
While assigning an auxiliary to mode 2, the
Fader for that channel will not function. It will act
as moving the channel.
While assigning an auxiliary to mode 3, the
channel fader and the auxiliary controls will both
work for that channel on an HTP (highest takes
precedent) operating principle.
17 January 31, 2012