Setup; Ac Power; Resetting The Breaker - Chauvet Arena Hazer 3 User Manual

3. S
ETUP

AC Power

This product uses a transformer-based power supply with a fixed input voltage of
either 120 V, 60 Hz or 230 V, 50 Hz.
To determine the power requirements for a particular fixture, see the label affixed to
the back plate of the fixture or refer to the fixture's specifications chart. A fixture's
listed current rating indicates its average current draw under normal conditions.

Resetting the Breaker

This product is equipped with a resettable circuit breaker on the power input circuit.
In the event that the breaker trips, the power will be cut to the entire product. Please
see the instructions below for resetting this breaker.
1) Remove the power cord from mains power.
2) Allow unit to cool for 15 minutes.
3) After 15 minutes, you may attempt to reset the breaker by pressing the button with
4) Plug the fixture power cord into the power outlet and continue recommended use.
Page 6 of 16
Always connect this product to a protected circuit (circuit breaker or fuse),
making sure that it has an appropriate electrical ground to avoid the risk of
electrocution or fire.
Never connect this product to a rheostat (variable resistor) or dimmer circuit,
even if the rheostat or dimmer channel serves only as a 0 to 100% switch.
your index finger.
In the event that the breaker will not reset (the breaker button will not remain
inserted), contact CHAUVET® immediately, as this indicates a possible internal
malfunction.
Arena™ Hazer 3 User Manual (Rev. 01d)