Information Display; Details - Waterstage Air to Water Operation Manual

Air to Water Heat Pump
3.8

Information display

Various data can be displayed by pressing the info
button.
Depending on the type of unit, configuration and
operating state, some of the info lines listed below may
not appear.
- Possible error messages: The display shows the "Bell"
symbo .
" Consult your heating technician.
- Service messages ; Special mode messages:
The display shows the "Key" symbol
" Consult your heating technician.
- 16 -
- Various data (see below).
Designation
Floor drying current setpoint .
Current drying day.
Terminated drying days.
State heat pump.
State supplementary source.
State DHW.
.
State swimming pool.
State heating circuit 1.
State heating circuit 2.
State cooling circuit 1.
Outdoor temperature.
Room temperature 1.
Room setpoint 1.
Flow temperature 1.
Flow temperature setpoint1.
Room temperature 2.
Room setpoint 2.
Flow temperature 2.
Flow temperature setpoint 2.
DHW (domestic hot water) temperature.
Heat pump return temperature.
Setpoint (return) HP.
Heat pump flow temperature.
Setpoint (flow) HP.
Swimming pool temperature.
Swimming pool temperature setpoint.
Minimum remaining stop time for compressor 1.
Minimum remaining running time for compressor 1.
3.9
If the electrical power supply has been cut off while
the heat pump is operating (electrical power failure or
unprogrammed pressing of the on/off switch on the
hydraulic unit) the display will show error 370 when
the appliance restarts. Do not be concerned, the
communication between the outdoor and hydraulic unit
will re-establish itself in a few moments.

Details

Operation manual "1534 - EN"
Line
-
-
-
8006
8022
8003
8011
8000
8001
8004
8700
8740
8743
8770
8773
8830
8410
8412
8900
-
-