Mounting Under A Continuous Worktop; Rehingeing The Door; Starting Up And Temperature Regulation; Correct Storage - AEG Automatic Refrigerator Operating Instructions Manual

Mounting under a continuous
worktop
Fig. 3
If installed under a continuous worktop, the appliance
is fastened with a mounting screw (A) under the panel.
For this purpose, one of the rear mounting screws of
the detached worktop can be used.

Rehingeing the door

Figs. 4, 5, 6
Before connecting your appliance to the power
supply, you should check whether the door hinge
should be changed over from right (as delivered) to
left if required by the installation site and operability.
1. Tilt the appliance slightly towards the rear and
prop it securely.
2. Unscrew the door hinge screws (K) and take the
door bearing (1) downwards out of its cavity
(Fig. 4).
3. Open the door a little way and take it out down-
wards.
4. Unscrew the upper pin (A) (Fig. 5) and screw it
into place on the opposite side.
5. Fit the door into the upper pin (A) and close it.
6. Insert the pin of the door bearing (1) into the left
hand cavity and screw the bearing firmly into
place with the screws (K).
7. Unscrew the door handle and screw it in place
on the left-hand side of the door. Use the plastic
caps to cover the unused screw holes (Fig. 6).
Cleaning before using for the
first time
Like all new appliances, your refrigerator will smell
"new". For this reason, the interior of the refrigerator
and all accessories should be cleaned before use
(see also "Cleaning and care").
The rating plate is located inside the appliance.

Plug socket

Fig. 7
The plug socket necessary for connection of your appli-
ance to the electricity supply should be positioned so
that it is possible to pull out the appliance plug.
If your appliance is installed under a continuous
worktop, the plug socket should be provided as
shown in Fig. 7.
A concealed protective contact plug socket re-
quires 10 A/16 A fusing.
Starting up and temperature
regulation
Fig. 8
Insert the plug of the connection lead into the plug
socket with protective earth contact.
When the refrigerator compartment door is opened,
the internal lighting is switched on.
The temperature selector knob is located on the RH
side of the refrigerator compartment.
Setting "0" means: Off.
Turning clockwise in direction "1": Refrigerating
unit on, the latter then operating automatically.
Setting "1" means: Highest temperature, warm-
est setting.
Setting "6" (end-stop) means: Lowest tempera-
ture, coldest setting.
a) For normal refrigeration, we recommend setting
"3". If you require a lower temperature, select
setting "4".
b) For icemaking, rapid refrigeration, and short-
term storage of frozen food in the icemaking
compartment, select setting "5" or "6".
The internal temperature is strongly affected by the
ambient temperature, loading, and frequent door
opening.

Correct storage

Fig. 9
1 = Butter and cheese
2 = Eggs, tubes, preserves
3 = Drinks
4 = Cheese storage, fruit, and vegetables
5 = Meat, salami, cold cuts, dairy produce
6 = Ready meals, pastries, preserves
7 = Icemaking compartment for rapid refrigera-
tion, icemaking, and short-term storage of fro-
zen food
GB
13