Detaching The Worktop; Electrical Connection; Rehingeing The Door; Mounting Under A Continuous Worktop - AEG Automatic Refrigerator Operating Instructions Manual

Special accessories:
A = Ventilation grille, brown (E-No. 621 814 002)
B = Ventilation grille, white (E-No. 621 825 004)

Detaching the worktop

Fig. 2
After removal of the worktop of your refrigerator, the
appliance can be installed under a continuous
worktop. To do this, proceed as follows:
Unscrew the Phillips screws (A).
Unscrew the front screws (C).
Mounting under a continuous
worktop
Fig. 3
If installed under a continuous worktop, the appli-
ance is fastened with a mounting screw (A) under
the panel.

Rehingeing the door

Figs. 4, 5, 6
Before you connect the appliance to the power
supply you should check whether the door should
close to the right (as delivered) or should better be
changed over to the left if the position and ease of
use require. If so:
1. Tilt the appliance slightly towards the rear and
prop it securely.
2. Unscrew the door hinge screws (K) and take the
door bearing (1) downwards out of its cavity
(Fig. 4).
3. Open the door a little way and take it out down-
wards.
4. Unscrew the upper pin (A) (Fig. 5) and screw it
into place on the opposite side.
5. Fit the door into the upper pin (A) and close it.
6. Insert the pin of the door bearing (1) into the left
hand cavity and screw the bearing firmly into
place with the screws (K).
7. Unscrew the door handle and screw it in place on
the opposite d side of the door. Use the plastic
caps to cover the unused screw holes (Fig. 6).
Cleaning before using for the
first time
Like all new appliances, your refrigerator will smell
"new". For this reason, the interior of the refrigerator
and all accessories should be cleaned before use
(see also "Cleaning and care").

Electrical connection

WARNING - THIS APPLIANCE MUST BE
EARTHED
Please ensure that the voltage and current indicated
on the rating plate agrees with the voltage of your
electricity supply.
220/240 volts ~ (i. e. 220/240 V AC).
If your appliance has been equipped with a mains
lead with a moulded-on type plug, you must comply
with the following regulations: The plug moulded on
to the cord incorporates a fuse. For replacement,
use a 13 amp BS 1362 fuse. Only ASTA approved
or certified fuses should be used. The fuse cover/
carrier must be replaced in the event of changing
the fuse. The plug must not be used if the fuse
cover/ carrier is lost. A replacement cover/carrier
must be obtained from an electrical goods retailer. If
the socket outlets in your home are not suitable for
the plug fitted to the appliance, then the plug must
be cut off and an appropriate one fitted. When
fitting the plug please note the following points:
Important
The wires in the mains lead are coloured in accord-
ance with the following code:
Green and Yellow
Blue
Brown
As the colours of the wires in the mains lead of this
appliance may not correspond with the coloured
markings identifying the terminals in your plug,
proceed as follows:
1. The wire which is coloured GREEN and YEL-
LOW must be connected to the EARTH termi-
nal in your plug, which is marked with the letter
E or by the earth symbol
GREEN, or GREEN and YELLOW.
2. The wire which is coloured BROWN must be
connected to the LIVE terminal which is marked
with the letter L or coloured RED.
3. The wire which is coloured BLUE must be con-
nected to the neutral terminal which is marked
with the letter N or coloured BLACK.
GB
Earth
Neutral
Live
or coloured
11