Mounting Under A Continuous Worktop; Rehingeing The Door - AEG OKO-SANTO series Operating Instructions Manual

Mounting under a continuous worktop

If installed under a continuous work-
top, the appliance is fastened with a
mounting screw (A) under the panel.

Rehingeing the door

The side at which the door opens can be changed from the right side
(factory adjustment) to the left side, if the installation site requires.
Warning! When changing the side at which the door opens, the appli
ance may not be connected to the mains. Remove plug from the
mains beforehand.
Tilt the appliance slightly towards the
rear and drop it securely.
Unscrew the door hinge screws (K)
and take the door bearing (1) down-
wards out of its cavity.
Open the door a little way and take it
out downwards.
Unscrew the upper pin (A) and srew it
into place on the opposite side.
Fit the door into the upper pin (A)
and close it.
Insert the pin of the door bearing (1)
into the left hand cavity and screw
the bearing firmly into place with the
screws (K).
48
AEG96
AEG97
12
A
AEG98
A
1
K