Table of Contents
Advertisement
4
Setting POP server
When "POP before SMTP" is selected at
"Auth" of "SMTP Authentication setting",
enter "POP server*
and click Set button.
*2 The POP server is a server for receiving e-mail.
Please contact your network administrator to have this POP server address.
Error message for sending alert mail
When the projector has an abnormality, an
alert message will be sent to the registered
E-mail address.
If the SMTP server is missing or the authen-
tication is not completed because of input
error in E-mail address setting or SMTP
authentication setting when sending alert
e-mail, the error message will be displayed.
Please check the respective settings.
5
Option selection for sending alert mail
Click Option sub menu tab. Check the
condition items under which alert mail
will be sent and click Set button.
Please refer to item "Examples :Type and
contents of alert mail" described on the
next page.
✐ "When PJ lamp is off" signifies the lamp goes out without user operation. "When PJ is turned into
Standby in proper user operation" signifies that the projector is turned on by using the web browser
and then it is turned into standby with ON/STANDBY button on the side control or the remote control.
Up to 99,999 hours can be set for use time.
✐
L2K1000 Network User Manual
020-00395-01 Rev.1 (04-2011)
" and "POP server port"
2
Error message for missing SMTP server
Error message for authentication problem
Option
E-mail setting
Error information
Error information
27
Advertisement
Table of Contents
