Gearboxes - Volvo V40 Cross Country Owner's Manual

Hide thumbs Also See for V40 Cross Country:
Table of Contents

Advertisement

4. Connect one of the red jump lead's
clamps to the donor battery's positive
terminal (1).
IMPORTANT
Connect the start cable carefully to avoid
short circuits with other components in the
engine compartment.
5. Open the clips on the front cover of the
battery in your car and remove the cover.
6. Connect the red jump lead's other clamp
onto the car's positive terminal (2).
7. Connect one of the black jump lead's
clamps to the donor battery's negative
terminal (3).
8. Connect the other clamp to a grounding
point, e.g. right-hand engine mounting at
the top, the outer screw head (4).
9. Check that the jump lead clamps are
affixed securely so that there are no
sparks during the starting procedure.
10. Start the engine of the "donor car" and
allow it to run a few minutes at a speed
slightly higher than idle
approx. 1500 rpm.
11. Start the engine in the car with the dis-
charged battery.
IMPORTANT
Do not use the connections when attempt-
ing to start, as there is a risk of sparking.
12. Remove the jump leads in reverse order -
first the black and then the red.
> Make sure that none of the black jump
lead's clamps comes into contact with
the battery's positive terminal or the
clamp connected to the red jump lead!
WARNING
The battery can generate oxyhydrogen
gas, which is highly explosive. A spark
can be formed if a jump lead is con-
nected incorrectly, and this can be
enough for the battery to explode.
The battery contains sulphuric acid,
which can cause serious burns.
If sulphuric acid comes into contact
with eyes, skin or clothing, flush with
large quantities of water. If acid
splashes into the eyes - seek medical
attention immediately.
Related information
Starting the engine (p. 268)
08 Starting and driving

Gearboxes

There are two main types of gearbox - Manual
and Automatic.
Manual gearbox (p. 272)
Automatic gearbox - Geartronic (p. 273)
and Powershift (p. 276)
IMPORTANT
To prevent damage to any drive system
components, the working temperature of
the gearbox is checked. If there is a risk of
overheating, a warning symbol in the com-
bined instrument panel lights up and a text
message is shown. Follow the recommen-
dation given in the text message.
08
271

Advertisement

Table of Contents
loading

This manual is also suitable for:

V 40

Table of Contents