Volvo V40 Cross Country Owner's Manual page 269

Cold or hot weather
The colder the weather the longer it takes
before the Alcolock is ready for use:
Temperature (ºC) Maximum heat-
ing time (sec-
onds)
+10 to +85
-5 to +10
-40 to -5
At temperatures below -20 ºC or above
+60 ºC the Alcolock requires additional power
supply. The combined instrument panel
Alcoguard insert power cable
shows
which case, connect the power supply cable
from the glovebox and wait until indicator
lamp (6) is green.
In extremely cold weather the heating time
can be reduced by taking the Alcolock
indoors.
Emergency situation
In the event of an emergency situation or the
Alcolock is out of order, it is possible to
bypass the Alcolock in order to drive the car.
An authorised Volvo workshop is recommended.
6
NOTE
All activation with bypass is logged and
saved in a memory; see Recording data (p.
17).
After the Bypass function has been activated
the combined instrument panel shows
Alcoguard Bypass enabled
10
while driving and can only be reset by a work-
60
shop 6 .
The Bypass function can be tested without
180
the error message being logged - in which
case, carry out all the steps without starting
the car. The error message is cleared when
the car is locked.
. In When the Alcolock is installed, either the
Bypass or Emergency function is selected as
the bypassing option. This setting can be
changed afterwards at a workshop
Activating the Bypass function
•
Depress and hold the left-hand stalk
switch OK button and the button for haz-
ard warning flashers simultaneously for
approx. 5 seconds - the combined instru-
ment panel first shows
Wait 1 minute
Bypass enabled
can be started.
This function can be activated several times.
The error message shown during driving can
only be cleared at a workshop
Activating the Emergency function
•
the whole time
This function can be used once, after which a
reset must be made at a workshop
Related information
•
6
.
Bypass activated
Alcoguard
and then
- after which the engine
*
Option/accessory, for more information, see Introduction.
08 Starting and driving
6 .
Depress and hold the left-hand stalk
switch OK button and the button for haz-
ard warning flashers simultaneously for
approx. 5 seconds - the combined instru-
ment panel shows Alcoguard Bypass
enabled and the engine can be started.
Alcolock* (p. 264)
6
.
08
267