Installing The Power Supply; Finishing Up - TYAN Toledo i3210W Manual

2.11 - Installing the Power Supply

There are two power connectors on your mainboard. The board requires that you
use an EPS12V power supply that has a 24-pin and an 8-pin power connector.
Please be aware that ATX 2.x, ATX12V and ATXGES power supplies are not
compatible with the motherboard and can damage.
EPS12V (24-pin)
Applying power to the board
1. Connect the EPS 12V 8-pin power connector.
2. Connect the EPS 12V 24-pin power connector.
3. Connect power cable to power supply and power outlet
YOU MUST unplug the power supply before plugging the power cables
NOTE
to motherboard connectors.

2.12 - Finishing Up

Congratulations on making it this far! You're finished setting up the hardware aspect
of your computer. Before closing up your chassis, make sure that all cables and
wires are connected properly, especially IDE cables and most importantly, jumpers.
You may have difficulty powering on your system if the motherboard jumpers are
not set correctly.
In the rare circumstance that you have experienced difficulty, you can find help by
asking your vendor for assistance. If they are not available for assistance, please
find setup information and documentation online at our website or by calling your
vendor's support line.
EPS12V (8-pin)
31
http://www.tyan.com