Table of Contents
Advertisement
TROUBLE SHOOTING
FAULT
Fixture does not turn on
Output power seems low
Fixture does not respond
to DMX signal
Scanner loses position on
one or more of its functions.
The head does not respond
to the music in sound or
controller sound activated
strobe.
CHECK
Check power line connection and fuse. If they are in working order, contact your dealer.
Check to see that the mirror and front lens are clean.
Check the control cable from the controller and along the chain. Check for a bad
connection or a bad cable. Check that pin 1 goes to pin 1, 2 to 2 and 3 to 3. Check that
the terminator plug is correctly attached at the end of the chain (100 Ohm across pins
2 & 3 of XLR connector) Check that the DMX address is set to the required channel.
Check that the motors can move freely and are not hindered. If they seem to be
working properly, contact your dealer.
Check that the unit is close enough to a mid-range sound source. Try gently tapping
the built-in-microphone to see if it responds. If so, move it closer to the audio source.
Advertisement
Table of Contents
