Table of Contents
Advertisement
SPECIFICATIONS
Lamp:
ELC 24V 250W
Motor(s):
4 Precision micro-stepping motors 1.8/step
Gobos:
13
Color:
10 solid colors, 10 bi-color combinations plus open
Modes of Operation:
Stand-alone Auto, Sound Active, Master/Slave, DMX
DMX Channels:
4
Pan:
165°
Tilt:
114°
Cooling:
Fan
Input Power:
120VAC 60Hz
Dimensions:
L 17.7" x W 6.2" x H 6.1"
Weight:
16.5 lbs. / 7.5 kg
SAFETY INSTRUCTIONS
Read user manual before connecting or operating your dual scanner.
• Always completely disconnect the scanner and allow to cool down for 15 minutes before replacing the lamp or fuse.
• Do not use the scanner near water.
• Do not block fan or exhaust vents in area of scanner use.
• Do not install scanner anywhere near heat sources such as radiators, heat registers, stoves or other apparatus
that produces heat.
• Unplug your scanner when unused for long periods of time.
• Refer all servicing to authorized service personnel.
• Room temperature when scanner is in use should not exceed 104° F.
INSTALLATION AND SET UP
To hang the fixture, install a "C" or "S" clamp to the yoke through the 1/2" hole, the head is now ready for permanent
installation. Hang the unit and position it as necessary and tighten the hex bolt. When the required angle is reached,
lock the fixture with the thumbscrew.
CAUTION:
• Do not mount the unit near curtains or any flammable objects.
• The scanner is for indoor use only. Using the scanner outdoors will void the warranty.
• Cables conforming to the DMX standard (USITT DMX512/1990) must be used.
REPLACING LAMP
1. Unplug the scanner completely from the electrical outlet and wait for the unit to cool, about 15 minutes.
2. Unscrew the fixing screw of the lamp window cover on the rear of the unit.
3. Take the lamp and socket out of the unit body gently. Do not touch the bulb with bare hands. Use gloves or handle
the lamp by its base only.
4. Place the new lamp and socket into the unit and then fasten the lamp cover screws.
Advertisement
Table of Contents
