How To Select Functions - Venue Lighting Effects Dual Scanner User Manual

HOW TO SELECT FUNCTIONS:

DMX Receipt Mode:
Flip DIP Switch #11 to "OFF", the fixture is now in DMX receipt mode. DIP Switch #1 through #9 set the DMX address
of the fixture.
Auto Mode:
When using one fixture only, put DIP switch #11 "ON". This places the unit into Stand Alone Auto Mode. Flip DIP Switches
#1 through #6 to the "ON" position to activate built-in programs. To adjust the speed of the program refer to the chart below
and turn "ON" corresponding DIP Switch for desired speed. DIP Switches #7 through #9 are used in combinations of ON/
OFF states to adjust playback speed.
When using more than one fixture you will need to set the first fixture in the series as the Master and the subsequent
ones as slaves.
IMPORTANT
Connect all fixtures to the master in a series using standard DMX 3-Pin XLR cables. Set all DIP switches properly as
shown below.
You should not run Auto Modes when connected in the same data line as DMX operated fixtures as addition data sent
from the Master may impede the functionality of your DMX fixtures.
To Set the Master, turn DIP switch #11 ON and #10 OFF. Turn on DIP switch #1 through #6 to run the preprogrammed
sequences stored in the fixture. DIP Switches #7 through #9 are used in combinations of ON/OFF states to adjust
playback speed.
To set the units to Slave, turn OFF switch #11. The SLAVE unit will then receive its control signal from the Master as long
as it is connected to a properly configured Master.