Table of Contents
Advertisement
SOUND ACTIVE MODE
When using one fixture only, put DIP switch #11 "ON": This places the unit into Stand Alone Sound Active Mode and select
DIP Switches 1-6 to the "ON" position to activate built in programs. To adjust the speed of the program refer to the chart
below and turn "ON" corresponding DIP Switch for desired speed. DIP Switches #7 through #9 are used in combinations
of ON/OFF states to adjust playback speed.
When using more than one fixture you will need to set the first fixture in the series as the Master and the subsequent
as slaves.
IMPORTANT
Connect all fixtures to the master in a series using standard DMX 3-Pin XLR cables.
Set all DIP switches properly as shown below.
You should not run Stand Alone Sound Active Modes when connected in the same data line as DMX operated fixtures as
addition data sent from the Master may impede the functionality of your DMX fixtures. To Set the Master, turn DIP switch
#11 on and #10 OFF. Turn on DIP switch #1 through #6 to run the preprogrammed sequences stored in the fixture. DIP
Switches #7 through #9 are used in combinations of ON/OFF States to adjust playback speed.
To set the units to Slave, turn OFF switch #11. The Slave unit will then receive its control signal from the Master as long as
it is connected to a properly configured Master.
To set the units to Slave, turn OFF switch #11. The Slave unit will then receive its control signal from the Master as long as
it is connected to a properly configured Master.
SPEED CONTROL CHART
Speed No
1
2
3
4
5
6
7
8
DIP #12 Swap Pan Tilt Channels When ON
DIP #13 Inverts Pan When ON
DIP #14 Inverts Tilt When ON
DIP #7
DIP#8
DIP#9
OFF
OFF
OFF
ON
OFF
OFF
OFF
ON
OFF
ON
ON
OFF
OFF
OFF
ON
ON
OFF
ON
OFF
ON
ON
ON
ON
ON
Time in Seconds/Step
2
3/2
1
3/4
1/2
3/8
1/4
1/5
Advertisement
Table of Contents
