Step 2 Adjust Leveling Legs - Danby DDW2405W Installation Instructions Manual

STEP 2 ADJUST LEVELING LEGS

Measure installation height and dishwasher
height. Extend leveling legs out from the dish-
washer base, 1/4" less than installation height.
STEP 3 Remove Kick Plate
Remove the kickplate screws. Lift off the 2 piece
kickplate.
2 Kickplate
Screws
INSTALLATION INSTRUCTIONS
o
STEP 4 INSTALL 90
Wrap the 90 o elbow with thread seal tape, then install
it onto the water valve. To avoid damage to the
water valve bracket and/or fitting, do not over-
tighten the 90 o elbow. Position the end of the elbow
to face the rear of the dishwasher.
STEP 5 POSITION WATER LINE AND HOUSE
WIRING
• Position water supply and house wiring on the
floor of the opening to avoid interference with
base of dishwasher and components under
dishwasher.
5
ELBOW