Step 12 Connect Drain Line; Drain Line Installation - Danby DDW2405W Installation Instructions Manual

STEP 12 CONNECT DRAIN LINE

FOLLOW ALL LOCAL CODES
AND ORDINANCES
The drain hose molded end will fit 5/8", 3/4" or 1"
diameter connections on the air gap, waste tee or
disposer. Cut the marked line as required for your
installation.
• If a longer drain hose is required, add up to 42"
length for a total of 10ft. to the factory installed
hose. Use 5/8" or 7/8" inside diameter hose and
a coupler to connect two hose ends. Secure the
connection with hose clamps.
• Secure the drain hose to the air gap, waste
tee or disposer with clamps.
NOTE: TOTAL DRAIN HOSE LENGTH MUST NOT EXCEED
10 FEET FOR PROPER DRAIN OPERATION.
INSTALLATION INSTRUCTIONS

DRAIN LINE INSTALLATION

• Connect drain line to air gap, waste tee or disposer
using either of the previously determined method.
Method 1 - Air gap with waste tee or disposer
Method 2 - High drain loop with waste tee or disposer
IMPORTANT -
When connecting the drain line to
the disposer, check to be sure that
the drain plug has been removed.
DISHWASHER WILL NOT DRAIN IF
PLUG IS LEFT IN PLACE.
TIP: Avoid unnecessary service call charges. Always
be sure disposer drain plug has been removed before
attaching dishwasher drain hose to dispenser.
9