Table of Contents
Advertisement
i
Avoid opening the door of frozen food
compartment during freezing if possible.
i
It is not expedient to set the thermostat knob
to higher (e.g. max) position. Freezing time could
be reduced this way, but the temperature of the
fresh food compartment would go beyond 0 ºC
permanently, which would cause freezing to foods
and drinks stored there.
i
Never freeze food in bigger quantity than
given in the "Technical data" at the same time,
otherwise freezing will not be thorough and
after dissolving various deterioration may take
place (losing taste and aroma, lysing, etc.).
Storing in the freezer
After finishing freezing it is practical to put the
frozen food from the wire drawer in the frozen
food compartment into the basket under that
making room for a next possible freezing. Food
already stored is not damaged by another freezing.
i
Do not forget to keep to the storage time
given on the packaging of frozen products if you
buy them frozen.
i
It is safe to store quick-frozen, frozen foods
only if they have not dissolved even for a short
time until placing them into freezer.
If the deep-frozen food has already dissolved,
refreezing is not recommended, it has to be used
as soon as possible.
i
Some useful information and advice
The variable shelves are worth paying attention
to, which increases the usability of the fresh
food compartment considerably. Rearranging
the shelves is also possible when the door is
open at an angle of 90.
After opening and closing the door of freezer
vacuum will rise inside the appliance because
of the low temperature. So wait 2-3 minutes
after closing the door if you want to open it
again while inner pressure equalizes.
Take care of operating the freezer at a position
of thermostatic control so that the inside
temperature can never be warmer than -18 ºC
It is practical to make sure of faultless
operation of the appliance daily so as to notice
possible failure in time and prevent
deterioration of frozen foods.
Normal operating sounds:
o A thermostat controls the compressor and you
will hear a faint click when thermostat cuts in
and out.
o You may hear faint gurgling or bubbling sound
when the refrigerant is pumped thorough the
coils at the rear, to the cooling plate/evaporator.
o When the compressor is on, the refrigerant is
being pumped round and you will hear a
whirring sound or pulsating noise from the
compressor.
o The fridge evaporator (this part cool down the
fridge section) is foamed into the cabinet. The
temperature of this part changing during its
work, and parallel with this its dimensions are
slightly changing, too. These changes might
cause a cracking noise, which is natural,
harmless phenomenon.
Should you want to check the temperature of
food stored in the refrigerator, set the
thermostat knob into a medium position, place
a glass of water centrally in the cabinet, and
put a proper thermometer with an accuracy of
+/- 1 ºC into it. If after 6 hours you
!
measure a value between +3 ºC and +8 ºC
the refrigerator works properly. The
measuring shall be performed under steady-
stated conditions (without changing the load).
If the freezer temperature is measured using a
thermometer, put it between the products
since this will reflect the real temperature in
the frozen products.
Hints and ideas
In this chapter practical hints and ideas are given
about how to use the appliance to reach maximum
energy saving and there is environmental
information about the appliance as well. using a
thermometer, put it between the products since
this will reflect the real temperature in the frozen
products.
5
The plastic bag of accessories also contains two
spacers to be fitted into special holes in the
back of the appliance. Fit the spacers into the
holes, taking care to ensure that the spacer is
positioned as shown in Figure. Then turn them
through 45° until they lock into place.
Do not stand the appliance on a sunny place or
close to a radiator or cooker.
If it is unavoidable because of furnishing and the
appliance has to be stood near a cooker take these
minimum distances into consideration:
In case of gas or electric cooker 3 cm must be left,
when it is less put a 0,5 - 1 cm non-flam insulation
between the two appliances.
In case of oil or coal-fired stove the distance must
be 30 cms since they give off more heat.
The refrigerator is designed to operate when it is
totally pushed to the wall.
When placing the refrigerator keep minimal
!
distances recommended in figure.
A: placing it under a wall-cupboard
B: placing it freely
Change of door opening direction
Should the setting-up place or handling demand it,
door opening direction
can be refilled from
right-handed to left-
handed.
Appliances on the
market are right-
handed.
Following operations
are to be done on the
basis of figures and
explanations:
D i s c o n n e c t t h e
appliance from the
electricity supply.
T i l t b a c k t h e
appliance carefully. It
is recommended to
ask another person for
help, who can keep
the appliance at this
position safely.
Remove cover from
the upper door mask,
and remove upper
door shaft (Figure 1).
Take off the door of
the Refrigerator by
pulling it slightly
upwards.
Dismount the double
d o o r h o l d e r b y
removing two screws
in front (Figure 2).
Take off the door of
the freezer by pulling
it slightly upwards,
and remove plastic
door limiter from the
bottom of the door by
removing the screw.
Install left door limiter
enclosed in the bag of
spare parts (Figure 3).
Remove the refrigerator work plate (figure 5).
Unscrew the upper door hinge of the
refrigerator, and then screw it back on the
other side (Figure 6).
Remove the screws of the lower door hinge on
the left side and screw it back on the other side
of refrigerator (Figure 6).
Fit the door of the freezer to the lower door
hinge.
10
Advertisement
Table of Contents
