Table of Contents
Advertisement
• [NTSC]- For TV with NTSC color
system.
4
To return to the previous menu, press
5
To exit the menu, press .
Set up EasyLink (HDMI-CEC
control)
This unit supports Philips EasyLink, which
uses the HDMI-CEC (Consumer Electronics
Control) protocol. EasyLink-compliant devices
that are connected through HDMI can be
controlled by a single remote control.
Note
•
Depending on the manufacturer, HDMI-CEC is known
by many names. For information about your device, see
the user manual of the device.
•
Philips does not guarantee 100% interoperability with
all HDMI-CEC devices.
Before you start
•
Connect your product to the HDMI-
CEC compliant device through HDMI
connection.
•
Make the necessary connections described
in the short user manual, and then switch
the TV to the correct source for your
home theater.
Enable EasyLink
1
Press
(Home).
2
Select [Setup], and then press OK.
3
Select [Video], and then press OK.
4
Select [HDMI Setup] > [EasyLink Setup]
> [EasyLink] > [On].
5
On your TV and other connected devices,
turn on HDMI-CEC control. For details, see
the user manual of the TV or other devices.
• On your TV, set the audio output to
'Amplifier' (instead of TV speakers).
For details, see the TV user manual.
12
EN
EasyLink controls
With EasyLink, you can control your home
theater, TV, and other connected HDMI-CEC
.
compliant devices with a single remote control.
[One Touch Play]: If one-touch play is
•
enabled, press
your unit to wake up the TV from standby.
•
[One Touch Standby]: If one-touch standby
is enabled, your unit can switch to standby
with the remote control of the TV or other
HDMI-CEC devices.
[Sys Audio Control]: If system audio
•
control is enabled, the audio of the
connected device is output through your
unit's speakers automatically when you
play the device.
[Audio Mapping]: If system audio control
•
does not work, map the connected device
to the correct audio input connector on
your unit.
Note
•
To change the EasyLink control settings, press
(Home), select [Setup] > [Video] > [HDMI Setup] >
[EasyLink Setup] > [EasyLink].
Set up the audio
If you cannot hear the audio output of a
connected device through the unit, do the
following:
•
check if you have enabled EasyLink on all
the devices, and
•
on your TV, set the audio output to
"Amplifier" (instead of TV speakers). For
details, see the TV user manual, and
•
setup the EasyLink audio control.
1
Press
2
Select [Setup], and then press OK.
3
Select [Video], and then press OK.
4
Select [HDMI Setup] > [EasyLink Setup]
> [Sys Audio Control] > [On].
on the remote control of
(Home).
Advertisement
Table of Contents
