Table of Contents
Advertisement
Note
•
In DISC, USB, FM and AUX mode, the unit switches to
Eco Power Standby mode after 15 minutes in standby
mode.
•
In BT (Bluetooth) mode, the unit switches to Eco
Power Standby mode after 15 minutes in idle state.
To switch between standby mode and ECO
standby mode:
•
Press and hold
seconds.
Find the correct viewing
channel
1
Press SOURCE repeatedly to switch to
the disc source.
2
Turn on the TV and switch to the correct
video-in channel in one of the following
ways:
• Go to the lowest channel on your TV,
and then press the Channel Down
button until you see the blue screen.
• Press the source button repeatedly on
the remote control of your TV.
Tip
•
The video-in channel is between the lowest and highest
channels and may be called FRONT, A/V IN, VIDEO etc.
See the TV user manual on how to select the correct
input on the TV.
Select the correct TV system
Change this setting if the video is not displayed
correctly. By default, this setting matches the
most common setting for TVs in your country.
1
Press .
2
Select [Setup] (Setup) -> [Video] (Video)
-> [TV System](TV System).
for more than two
3
Select a setting and press OK.
• [PAL] (PAL) - For TV with PAL color
system.
• [Multi] (Multi) - For TV that is
compatible with both PAL and NTSC.
• [NTSC] (NTSC) - For TV with NTSC
color system.
4
To return to the previous menu, press
5
To exit the menu, press .
Change system menu
language
1
Press .
2
Select [Setup] (Setup) -> [General]
(General) -> [OSD Language] (OSD
Language), and press OK.
3
Select a setting and then press OK.
4
To exit the menu, press .
Set up EasyLink (HDMI-CEC
control)
This home theater supports Philips EasyLink,
which uses the HDMI-CEC (Consumer
Electronics Control) protocol. EasyLink-
compliant devices that are connected through
HDMI can be controlled by a single remote
control.
Note
•
Depending on the manufacturer, HDMI-CEC is known
by many names. For information about your device, see
the user manual of the device.
•
WOOX Innovations does not guarantee 100%
interoperability with all HDMI-CEC devices.
Before you start
•
Connect your product to the HDMI-
CEC compliant device through HDMI
connection.
.
EN
11
Advertisement
Table of Contents
