J5create USB VGA Display Adapter User Manual page 11

USB DISPLAY ADAPTER
6. After your computer is rebooted, connect the external display device
(monitor/ projector) to the VGA connector of the USB Display Adapter
and turn on the display device.
7. Connect the USB Display Adapter into an available USB 2.0 port of a PC
or Notebook, After Inserting the USB Display Adapter into an USB 2.0 port,
the "Installing device driver software" message will pop up.
If the Driver software was installed successfully the following message
should appear:
If you're not going to install another USB Display Adapter, restart your PC.
The functions of the USB Display Adapter will be activated after the
computer restarted.
Multi USB Display Adapter Installation
For installation of multiple USB Display Adapters, during the "Install Shield
Wizard complete" step, select "No, I will restart my computer later." and
click Finish to continue next step below
11
USER MANUAL