Table of Contents
Advertisement
A
K
7
7
-
8
X
M
a
x
A
K
7
7
-
8
X
M
a
x
*************************************************
Installing Drivers During Windows Me Installation
*************************************************
The following details the installation of the Serial ATA drivers while installing Windows Me (with the Serial ATA controller is
enabled already).
1. Install Windows Me fully.
2. After installation, go the "Start" menu and choose "Settings."
3. From the "Settings" menu, choose "Control Panel."
4. In the "Control Panel" window, double-click on the "System" icon.
5. In the "System" window, choose the "Device Manager" tab.
6. In the hierarchical display under "Other Devices" is a listing for "PCI Mass Storage Controller." Choose it and then press the
"Properties" button.
7. Choose "Reinstall Driver," and then press "Next."
8. Choose "Specify the location of the driver (Advanced)," then press "Next".
9. Insert the Promise SATA150 driver diskette into drive A:.
10. Choose "Specify a Location," and then type "A:\"
9a. Insert the "Bonus CD" in CD-ROM.
10a. Choose "Specify a Location," and then type
"[CD-ROM]:\Driver\Promise\SATA150\Driver\Win98-Me" in the text box.
11. Press the "Next" button. A message informing you that Windows Me has found
"Win98-ME Promise SATA150 TX2plus(tm) IDE Controller" should appear.
12. Press "Next," then "Finish".
********************************************
Confirming Driver Installation in Windows Me
********************************************
To confirm that the driver has been properly loaded in Windows Me,
perform the following steps:
1. Choose "Settings" from the "Start" menu.
2. Choose "Control Panel," and then double-click on the "System" icon.
3. Choose the "Device Manager" tab, and then click the "+" in front of "SCSI & RAID controllers".
"Win98-ME Promise SATT150 TX2plus(tm) IDE Controller" should appear.
96
O
n
l
i
n
e
M
a
n
u
a
l
O
n
l
i
n
e
M
a
n
u
a
l
Advertisement
Table of Contents
